UV-resistant cable  for Sinec-L2-DP and FIP (Factory Instrumentation Protocol)

Construction

• Conductor:                   bare Cu wire
• Core insulation:             expanded PE  
• Core colours:                red and green
• Cores twisted in layers, with optimal lay lengths                                         
• Overall screening with composite aluminium foil, metal layer on the outside, 
  and tinned copper braided Screening
• Inner jacket:                special PVC, flame retardant
• Outer sheath:                PE, UV-resistant
• Sheath colour:               black

Technical Datas

• Peak operating voltage:      max. 100 V
• Test voltage:                3600 V/3 sec.
• Conductor loop resistance:   max. 110 V Ohm/km
• Insulation resistance:       ≥ 16000 MOhm x km
• Mutual capacitance at 1 kHz: approx. 28.5 nF/km
• Bending radius:              single bending     min. 150 mm
                               repeated bending   min. 300 mm
• Temperature range:           -40°C to +60°C
• Wave impedance:              nominal value      150 Ohm
                               3 to 20 MHz        150 ± 15 Ohm
                               38.4 kHz           185 ± 18.5 Ohm
                               9.6 kHz            270 ± 27 Ohm
• Attenuation:                 at  16 MHz         < 45 dB/km
                               at   4 MHz         < 22 dB/km
                               at 38.4 kHz        < 5.0 dB/km
                               at   9.6 kHz       < 3.0 dB/km

Available special types

• with tinned Cu wire
• with steel tape armouring, type 02Y(St)CY(B)2Y, outer diameter approx. 10.8 mm